Flexure Tester is used to do bending test, meets standards: ASTM F963, 16 CFR 1500, GB6675-2.
Brand:
GESTERItem NO.:
GT-M44AOrder(MOQ):
1Payment:
T/T, L/CShipping Port:
Xiamen PortLead Time:
7 days after paymentProduct Detail
ASTM Flexure Tester GT-M44A
Application:
This ASTM Flexure Tester is used to test the metallic wires and other metallic components of a toy or part of a toy after repeated flexing, whether the toy will break and produce hazardous sharp points, or protrude through any surface covering of the toy.
Standards:
ASTM F963 16 CFR 1500 GB6675-2
|
1. The metallic wires and other metallic components shall be bent through a 60degree arc by a force applied perpendicularly to the major axis of the component at a point 2 ± 0.05 in. (50 mm) from the intersection of the component with the main body of the toy or applied at the end of the component if the component is less than 2 in. (50 mm) long. 2. The force shall be determined according to the age category . 3. The component shall then be bent in the reverse direction through a 120° arc. 4. This process shall be repeated for 30 cycles at a rate of 1 cycle/2 s, with a 60s rest period occurring after each 10 cycles. Two 120° arc bends shall constitute one cycle.
|
All kinds of metallic wire can be tested on the Flexure Tester.